Miniature High Density

316 stainless steel bodies with naval bronze engaging nut.
Bulkhead connectors available as a threaded or flanged version with a removable glass reinforced epoxy insert (not available with MHDG)
Cable connector plugs and receptacles are overmolded using polyurethane. Some connectors are also available with a neoprene overmold. The conductor insulation and jacket material of specified cable determines overmold material.
Cable connector plugs and receptacles are supplied unterminated unless cable termination is specified at time of order.
Straight or right angle OF adapters are available which allow the use of oil filled tubes with the cable connector plugs. Some adapters require the use of a special connector shell. Contact Impulse for further information.
Up to 10,000 PSI pressure rating in mated condition.
Bulkhead connectors open face pressure rated to 5,000 PSI.
Contacts gold plated per MIL-G-45204

All mounting surfaces require a 32 finish
Do not over tighten bulkhead connectors when mounting.
Care must be taken not to damage contacts in unmated connectors
Contact surfaces must be dry prior to mating.
Lubricate O-rings with Dow Corning #111 Valve Lubricant or equivalent.
Keep O-ring grooves clean and avoid cuts and nicks in the O-ring. Replace O-rings when re-mounting connectors.
Avoid contact with solvents.
Avoid sharp bends at cable entry to connector.
Elastomers can be seriously degraded if exposed to direct sunlight or high ozone levels for extended periods of time.

3,
4,5,7,8,9,10,12,14,16

600
300

9/16"-18

10,000

8,9,
12,16,24,26

600
300

7/8"-20

10,000

300

1"-20

10,000

38,49,61

300

1 1/8"-16

10,000

19, 55, 78

600

1 1/2" - 12

10,000