|
|
|
Miniature High Density
- 316 stainless steel bodies with naval bronze engaging nut.
- Bulkhead connectors available as a threaded or flanged version with a removable glass reinforced epoxy insert (not available with MHDG)
- Cable connector plugs and receptacles are overmolded using polyurethane. Some connectors are also available with a neoprene overmold. The conductor insulation and jacket material of specified cable determines overmold material.
- Cable connector plugs and receptacles are supplied unterminated unless cable termination is specified at time of order.
- Straight or right angle OF adapters are available which allow the use of oil filled tubes with the cable connector plugs. Some adapters require the use of a special connector shell. Contact Impulse for further information.
- Up to 10,000 PSI pressure rating in mated condition.
- Bulkhead connectors open face pressure rated to 5,000 PSI.
- Contacts gold plated per MIL-G-45204
- All mounting surfaces require a 32 finish
- Do not over tighten bulkhead connectors when mounting.
- Care must be taken not to damage contacts in unmated connectors
- Contact surfaces must be dry prior to mating.
- Lubricate O-rings with Dow Corning #111 Valve Lubricant or equivalent.
- Keep O-ring grooves clean and avoid cuts and nicks in the O-ring. Replace O-rings when re-mounting connectors.
- Avoid contact with solvents.
- Avoid sharp bends at cable entry to connector.
- Elastomers can be seriously degraded if exposed to direct sunlight or high ozone levels for extended periods of time.
|
| Connector |
# of Contacts |
Voltage Rating(VDC) |
Bulkhead Thread |
Mated Pressure Rating(PSI) |
|
|
| MHDG |
3,
4,5,7,8,9,10,12,14,16 |
600
300 |
9/16"-18 |
10,000 |
 |
|
| MHDL |
8,9,
12,16,24,26
|
600
300 |
7/8"-20 |
10,000 |
|
|
| MHDM |
24,26,36
|
300
|
1"-20 |
10,000 |
|
|
| MHDO |
38,49,61 |
300 |
1 1/8"-16 |
10,000 |
|
|
| MHDR |
19,55,78 |
600 |
1 1/2" - 12 |
10,000 |
|
|
| MHD Sealing Caps |
|
|
|
|
|
Top |
|
|
|
|