Impulse Products News Worldwide Inquiry Download Search
Connectors and Cables for Challenging Environments
Glass Reinforced Epoxy
  • Glass reinforced epoxy bulkhead connectors with solder pots. Potted pigtails available on request.
  • Cable connector plugs and receptacles can be overmolded using neoprene or polyurethane. The conductor insulation and jacket material of specified cable determines overmold material.
  • Cable connector plugs and receptacles are supplied unterminated unless cable termination is specified at time of order.
  • Special cable connector plugs available for use with oil filled tubes. (XSJ and XSL)
  • Up to 20,000 PSI pressure rating in mated condition. See specs for individual connector ratings.
  • Bulkhead connectors open face pressure rated to 5,000 PSI.
  • Contacts gold plated per MIL-G-45204
Usage
Specs



  • All mounting surfaces require a 32 finish
  • Do not over tighten bulkhead connectors when mounting.
  • These connectors should not be used in high impact areas, as chipping or cracking could occur.
  • Care must be taken not to damage contacts in unmated connectors
  • Contact surfaces must be dry prior to mating.
  • Lubricate O-rings with Dow Corning #111 Valve Lubricant or equivalent.
  • Keep O-ring grooves clean and avoid cuts and nicks in the O-ring. Replace O-rings when re-mounting connectors.
  • Avoid contact with solvents.
  • Avoid sharp bends at cable entry to connector.
  • Elastomers can be seriously degraded if exposed to direct sunlight or high ozone levels for extended periods of time.
Connector # of Contacts Bulkhead Thread
PDF Get Acrobat Reader
XSJ 2,3
4,5,7,9,10		 600
300		 9/16"-18 10,000
XSE 2
3
4
6,7
8
10
12
 800
700
600
500
400
300
250
 3/4"-16 10,000
XSL

2,4
5,6,8
10(#16)
10(#20), 12,14,16,20

 600
500
400
200
 1"-14 20,000
XSM 4,8,12,16
24,36
 600
400
 1 1/2"-12 10,000   Top

© 2007 Impulse Enterprise, Inc.            1-800-327-0971           +1-858-565-7050