|
|
|
Glass Reinforced Epoxy
Glass reinforced epoxy bulkhead connectors with solder pots. Potted pigtails available on request.
Cable connector plugs and receptacles can be overmolded using neoprene or polyurethane. The conductor insulation and jacket material of specified cable determines overmold material.
Cable connector plugs and receptacles are supplied unterminated unless cable termination is specified at time of order.
Special cable connector plugs available for use with oil filled tubes. (XSJ and XSL)
Up to 20,000 PSI pressure rating in mated condition. See specs for individual connector ratings.
Bulkhead connectors open face pressure rated to 5,000 PSI.
Contacts gold plated per MIL-G-45204
- All mounting surfaces require a 32 finish
- Do not over tighten bulkhead connectors when mounting.
- These connectors should not be used in high impact areas, as chipping or cracking could occur.
- Care must be taken not to damage contacts in unmated connectors
- Contact surfaces must be dry prior to mating.
- Lubricate O-rings with Dow Corning #111 Valve Lubricant or equivalent.
- Keep O-ring grooves clean and avoid cuts and nicks in the O-ring. Replace O-rings when re-mounting connectors.
- Avoid contact with solvents.
- Avoid sharp bends at cable entry to connector.
- Elastomers can be seriously degraded if exposed to direct sunlight or high ozone levels for extended periods of time.
|
| Connector |
#of Contracts |
Voltage Rating (VDC) |
Bulkhead Thread |
Mated Pressure Rating(PSI) |
|
|
| XSJ |
2,3
4,5,7,9,10 |
600
300 |
9/16"-18 |
10,000 |
 |
|
| XSE |
2
3
4
6,7
8
10
12
|
800
700
600
500
400
300
250
|
3/4"-16 |
10,000 |
|
|
| XSL |
2,4
5,6,8
10(#16)
10(#20), 12,14,16,20
|
600
500
400
200
|
1"-14 |
20,000 |
|
|
| XSM |
4,8,12,16
24,36
|
600
400
|
1 1/2"-12 |
10,000 |
|
Top |
|
|
|
|